200-101試験番号、700-270日本語

 

NO.1 Which command is used to enable CHAP authentication, with PAP as the fallback method, on a
serial interface?
A. Router(config-if)# authentication ppp chap fallback ppp
B. Router(config-if)# authentication ppp chap pap
C. Router(config-if)# ppp authentication chap fallback ppp
D. Router(config-if)# ppp authentication chap pap
Answer: D
Explanation:
http://www.cisco.com/en/US/docs/ios/12_2/security/configuration/guide/scfathen.html

NO.2 What does a router do if it has no EIGRP feasible successor route to a destination network and
the successor route to that destination network is in active status?
A. It routes all traffic that is addressed to the destination network to the interface indicated in the
routing table.
B. It broadcasts Hello packets to all routers in the network to re-establish neighbor adjacencies.
C. It sends a multicast query packet to all adjacent neighbors requesting available routing paths to
the destination network.
D. It sends a copy of its neighbor table to all adjacent routers.
Answer: C

200-101無料更新
Explanation:
Introduction to EIGRP Reference:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080093f07.shtml

NO.3 The following configuration is applied to a Layer 2 Switch:
interface fastethernet 0/4
switchport mode access
switchport port-security
switchport port-security mac-address 0000.1111.1111
switchport port-security maximum 2
swithcport port-security
What is the result of the above configuration being applied to the switch?
A. The switch can send an SNMP message to the network management station
B. A host with a mac address of 0000.1111.1111 and one other host can connect to Fast Ethernet 0/4
simultaneously
C. A host with a mac address of 0000.1111.1111 and up to two other hosts can connect to
FastEthernet 0/4 simultaneously
D. The port is effectively shutdown
E. Violating addresses are dropped and no record of the violation is kept
Answer: A,B

200-101資格試験
Explanation:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/20ewa/configuration/guide/port
_ sec.html

NO.4 Refer to the exhibit.
Given the output for this command, if the router ID has not been manually set, what router ID will
OSPF use for this router?
A. 192.168.5.3
B. 172.16.5.1
C. 10.154.154.1
D. 10.1.1.2
Answer: B
Explanation:
CCNA Tutorial: The OSPF Router ID (RID)
http://www.thebryantadvantage.com/CCNACertificationExamTutorialOSPFRouterIDRID.htm
When determining the Router ID (RID) of an OSPF-enabled router, OSPF will always use the
numerically highest IP address on the router's loopback interfaces, regardless of whether that
loopback is OSPF-enabled.
What if there is no loopback? OSPF will then use the numerically highest IP address of the physical
interfaces, regardless of whether that interface is OSPF-enabled.

JPshikenは Ciscoの200-101試験番号の認証に対して特別な教育ツールで、あなたに多くの時間とお金が使わないようにIT技術にも身につけさせるサイトでございます。JPshikenは専門家チームが自分の知識と経験をを利用してCiscoの200-101試験番号の問題集を研究したものでございます。

200-101試験番号:200-101問題集
試験科目:Interconnecting Cisco Networking Devices Part 2 (ICND2)
最近更新時間:2016-09-21
問題と解答:全149問 200-101試験番号
100%の返金保証。1年間の無料アップデート。

>> 200-101試験番号

 
700-270試験番号:700-270問題集
試験科目:NGFW Express for Account Managers (NGFWEAM)
最近更新時間:2016-09-21
問題と解答:全60問 700-270日本語
100%の返金保証。1年間の無料アップデート。

>> 700-270日本語

 

700-270日本語を選択したら100%試験に合格することができます。試験科目の変化によって、最新の試験の内容も更新いたします。700-270日本語のインターネットであなたに年24時間のオンライン顧客サービスを無料で提供して、もしあなたは700-270日本語に失敗したら、弊社が全額で返金いたします。

弊社のJPshikenはIT認定試験のソフトの一番信頼たるバンドになるという目標を達成するために、弊社はあなたに最新版のCiscoの700-270日本語を提供いたします。弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoの700-270日本語に順調に剛角しました。これも弊社が自信的にあなたに商品を薦める原因です。もし弊社のソフトを使ってあなたは残念で試験に失敗したら、弊社は全額で返金することを保証いたします。すべてのことの目的はあなたに安心に試験に準備さされるということです。

あなたはJPshikenが提供したCiscoの200-101試験番号の問題集だけ利用して合格することが問題になりません。ほかの人を超えて業界の中で最大の昇進の機会を得ます。もしあなたはJPshikenの商品がショッピング車に入れて24のインターネットオンライン顧客サービスを提供いたします。問題があったら気軽にお問いください、

購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード:http://www.jpshiken.com/200-101_shiken.html